• Applicable for:  ST70 Pilot Head
  • Software Version: 3.04
  • Release Date: September 2011
  • Replaces: v3.03, v2.05, v2.04, 1.07, 1.06
 

Downloading the Software


Select the software update below depending on which Multifunction Display you will be using to perform the Remote Update. Please note if you have a G Series or a/c/e/gS Series you must check what version of software you have installed in the unit that you are using to perform the upgrade. For further information on this please click here.


A Series C Series Classic E Series Classic C Series Wide E Series Wide G Series a/c/e/gS Series
A Series
DOWNLOAD
C Classic
NOT AVAILABLE
E Classic
DOWNLOAD
C Wide
DOWNLOAD
E Wide
DOWNLOAD
G Series
v2 DOWNLOAD
a/c/e/gS Series
v6 DOWNLOAD
          v4 DOWNLOAD v7 DOWNLOAD


View Update Instructions |  View Latest Manual


 

IMPORTANT TERMS OF DOWNLOADING SOFTWARE

 

This firmware update process is done at your own risk. Before initiating the update process be sure to backup and make copies of all important files

If the firmware process is interrupted your product may not function properly, therefore do not interrupt the process and ensure the unit is on a reliable power supply. Damage caused by incomplete upgrades will not be covered by Raymarine warranty. 

By Downloading the software, you agree to these terms.

 

 


Software History

  

Version

Release Date

 Features

v3.04

Sept 2011

  • Fixes Power up issue
 

v3.03

July 2010

 
  • Finnish, Portuguese & Polish Language support added.
  • Colour Modes 1/2/3, red/black and Inverse Colour Palettes now replace original to align with ST70+ Colour Modes.
  • System Brightness added. – Brightness can now be controlled globally via an ST70 or ST70+ Display & Keypad
  • Brightness Grouping added. – Can now be control individually, globally or within a defined Group of ST70 & ST70+.
  • Correction to E2 device write problem. – Corrects potential loss of internal / setup memory after long term use.
  • Changes to Bootloader (v0.21) & (v1.0) Software:
    • Bootloader (v0.21) assigns a unique ID: – It is now impossible to inadvertently program an ST70P with ST70I software and visa versa. This applies to programming with a G Series or any other compatible MFD. Note, after loading Bootloader v0.21 the software can not be downgraded to previous versions.
    • Bootloader (v1.0) includes the changes in (v0.21) and also allows easier software downloads with large Seatalk NG systems. - Note with previous Bootloader you may have to reduce the number of NG products on the bus.

    Changes to Raymarine Splash Screen (v1.0): 
    • Splash Screen graphics have now changed to align with ST70+, A Series, & C / E Series Widescreen MFD’s.
 

v2.05

May 2010

  •  
  • Cure for “watch dogging” - unit resetting fault.
  • Swedish language translation fixed. - Changes alarm message “No hard disk” to “No drive”.
  • Dodge mode locked last heading pop up now correct.
  • Bootloader (v0.21) now assigns unique ID: – It is now impossible to inadvertently program an ST70I with ST70P software and visa versa. This applies to programming with a G Series or any other compatible MFD.
  • After loading Bootloader v0.21 the software can not be downgraded to previous versions.
 

v2.04

June 2009

  • Full compatibility with release of SPXSOL & SPXCAN
 

v1.07

Jan 2009

  • Seatalk corruption fixed when connected to additional ST70 Displays or ST70P on a Seatalk NG spur
 

v1.06

Dec 2008

  • Initial Release